THE COMPREHENSIVE GUIDE ON USING A JOINTER

Working with wood can be a complicated process, and even more if you are not as experienced in the area. Even if you have done a lot of projects, dealing with new equipment can be quite confusing. One important tool that you will be using a lot is the jointer, and it is used for the purposes of making perfect squared boards. Even though, there are a lot different ways how for squaring the edges of a board, jointers help with precision and doing it just right. We have a guide for you to follow so you know how to use a bench top jointer.

You will be needing:

  • A jointer that is in adequate condition. You can find this anywhere online, and make sure you try to look for the best benchtop jointers under 500.
  • Wooden boards to cut
  • An angle gauge that is also known as the machinist’s square.

After you have the necessary things, you can start using the jointer by following these steps.

  • Make sure you are aware of the machine

You need to be extremely aware of the machine you are dealing with, this means knowing about all of its parts and what they do so you are able to maximise efficiency. In order to do this, you should read the user’s manual thoroughly. You should know how to adjust the fences, be able to change the blades, and be able to cut to the necessary depth and also know how to adjust the other parts of the machine in general. This will ensure safety and increased productivity.

  • Making sure the jointer is in tune

For proper tuning, the table on the jointer must be parallel to one another. To achieve this, the straight edge should be utilized which will be serving as point of comparison to make the necessary adjustments. For this, you should also read the user’s manual guide.

  • Make sure the jointer’s fence is squared up

To do this, you will be using the angle gauge that we talked about earlier, that will help you set the jointer fence perfectly. If the fence isn’t squared up, your jointer will be good for nothing, and it will make the jointer hard to use.

  • Knowing the board stock

You should refer to the manual about what board sizes will work with your jointer, because each jointer has its own capacity as to how much depth it can handle. You will have to check whether or not your board is of the right length when placing it on the table. If it is of the right length, it will be able to lay straight on the edge.

Hopefully, this guide should give you the necessary instructions so you can use if just how it is supposed to be used. It will take some time to get used to the machine completely, but once you get the hang of it your wood cutting will be impeccable.